Iranian Journal of Materials Science and Engineering

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

---

The effect of cooling rate after annealing at 900 °C on the microstructure and hardness of high entropy alloys was investigated using two typical samples with the chemical composition of Co₁₆Cr_14.5Fe₂₉Mn_11.5Ni₂₉ and Co_11.5Cr₇Fe₂₇Mn₂₇Ni₂₇(Nb_0.08C_0.5) (at%). The microstructural characterisation and hardness measurements were carried out by optical microscopy, scanning electron microscopy, wavelength-dispersive X-ray spectroscopy, electron back scattered diffraction, X-ray diffraction technique and Vickers hardness testing. A face centred cubic crystal structure matrix was observed in both alloys before and after annealing and regardless of cooling conditions. SEM analyses revealed an extensive precipitation in Co_11.5Cr₇Fe₂₇Mn₂₇Ni₂₇(Nb_0.08C_0.5) alloy after annealing. It was also found that air/furnace cooling can enhance grain growth-coarsening just in Co₁₆Cr_14.5Fe₂₉Mn_11.5Ni₂₉. However, the hardness results generally showed insignificant hardness variations in both alloys after water-quenching, air-cooling and furnace-cooling. The results suggested that the hardness is mainly controlled by solid solution strengthening.

Keywords: High entropy alloys, Cooling rate, Annealing, Microstructure, Hardness

Full-Text [PDF 5398 kb]   (3662 Downloads)    

Add your comments about this article : Your username or Email:

---

---