Iranian Journal of Materials Science and Engineering
Iran University of Science & Technology
Thu, Nov 14, 2024
[Archive]
Volume 11, Issue 3 (september 2014)
IJMSE 2014, 11(3): 67-74 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Mohammadzadeh A, Sabahi Namini A, Azadbeh M. DENSIFICATION AND MICROSTRUCTURE CHARACTERISTICS OF A PREALLOYED ALPHA BRASS POWDER PROCESSED BY LIQUID PHASE SINTERING . IJMSE 2014; 11 (3) :67-74
URL: http://ijmse.iust.ac.ir/article-1-684-en.html
URL: http://ijmse.iust.ac.ir/article-1-684-en.html
Abstract: (22105 Views)
The rapidly solidified prealloyed alpha brass powder with a size range of 40 to 100 μm produced by water
atomization process was consolidated using liquid phase sintering process. The relationships between sintering
temperature, physic-mechanical properties and microstructural characteristics were investigated. Maximum
densification was obtained at 930 °C, under 600 MPa compacting pressure, with 60 min holding time. The
microstructure of the sintered brass was influenced by dezincification and structural coarsening during supersolidus
liquid phase sintering. As a consequence of Kirkendall effect atomic motion between Cu and Zn atoms caused to
dezincification at the grain boundaries and formation of ZnO particles on the pore surfaces. It was concluded that
microstructural analysis is in a well agreement with obtained physical and mechanical properties. Also, the amount of
liquid phase, which depends on sintering temperature, results in different load bearing cross section areas, and it
affects the type of fracture morphologies.
Type of Study: Research Paper |
Send email to the article author
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
